TCS230 color sensor module
- үнэ: 20,000 төг
Description:
Designed around 4 White LEDs and the TAOS TCS230 sensor IC. The four white LED’s to provide a broad spectrum light source .The TCS230 has an 8 x 8 array of photodiodes with color filters (16 Red, 16 Blue, 16 Green, 16 Clear). A light to frequency converter generates a 50% duty cycle square wave on the output pin. Frequency is directly proportional to light intensity. Output scaling 100%, 20% and 2% allows for wide dynamic range of intensities. The color selects (S2, S3), frequency scale (S0, S1) and output are TTL logic level and can be connected directly to the micro controller. Basic readings are easy using the Arduino “pulsein” command. Take a reading for each color. The reading with narrowest pulse width or highest frequency is the major color. Using advanced ratio analysis almost any color could be recognized. Multiple uses by adding lenses, color filters, different light source.
Specifications:
- – Power: 2.7 – 5VDC
– Current: >30mA @ 5V
– Input: TTL Logic Levels
– Sensor Bandwidth: ~ 400 – 950nm
– Output: TTL Level Square Wave (50% Duty Cycle)
– ~2Hz max Dark/24KHz Max,
– Intensity/Color Dependant SEE DATA SHEET
– NOTE: The OE pin (Output Enable ) is grounded through R8 (0ohm), making the module enabled by default. Do not connect the OE to the micro controller, unless R8 is removed or changed to 4.7K or greater.
– Dual 4 Pin .1in Pitch Headers
– L: 1-1/4” W: 15/16” H: 3/4” WT: .03
